Pool Alarm Pool Protector
The POOLPROTECTOR pool alarm is the result of thorough and quality design and high manufacturing techniques. Pool Protector is an electronics monitoring system that automatically sounds an alarm when children or pet fall into your unsupervised pool. POOLPROTECTOR is a portable, self-contained, light weight unit that is safe and simple to operate. Entry into the pool will be detected by the unit’s electronics sensor, triggering a loud pulsating alarm and an internal RF transmitter.
The Pool Alarm installation is very easy. It sits on the pool deck as shown in picture. Uses a 9 volt battery (not included) After you install the POOL ALARM, it can't be de-activated; it is always in the alarm ready mode until you put it in Sleep Mode. (using included magnetic key) If someone who does not know how to put the POOL ALARM in sleep mode attempts to remove the alarm, it will sound an alarm. The Pool Alarm comes with a remote receiver which can be mounted in your home up to 200 feet from the main unit. It comes with a 12 volt power supply. The Pool Alarm uses one a 9-volt battery (not included) which should last approximately one year. There is a audible low battery indicator which will sound at the poolside alarm and the remote receiver.
POOL PROTECTOR is sold with a year limited warranty to cover defects in parts and workmanship for one year from date of purchase. Retain proof of purchase.
This product has been designed to aid in the detection of unwanted intrusions into unsupervised pools. POOL PROTECTOR IS A SAFETY ALARM SYSTEM AND NOT A LIFE SAVING DEVICE. “This device is not intended to replace any other safety consideration, adult supervision, lifeguards, fences, gates, pool covers, locks, etc., and some devices may not detect gradual entry.”
PROTECTOR has waterproof grade IPX5 But it is not submersible. So, if the pool unit accidentally falls into your pool, remove it immediately and drain the water from it. Take the unit apart as indicated in the Battery Replacement Procedure and remove the battery. Tip and shake unit and remove all excess water from inside the unit and the battery, and the circuit board area with a paper towel or cloth. Completely test unit before each use as described in manual to ensure proper operation
